41⟩ Define multicast routing?
Multicast routing is a targeted form of broadcasting that sends message to a selected group of user, instead of sending it to all users on a subnet.
“Network Administrator frequently Asked Questions in various Network Administrator job Interviews by interviewer. The set of questions here ensures that you offer a perfect answer posed to you. So get preparation for your new job hunting”
Multicast routing is a targeted form of broadcasting that sends message to a selected group of user, instead of sending it to all users on a subnet.
Encryption is the process of translating information into a code that is unreadable by the user. It is then translated back or decrypted back to its normal readable format using a secret key or password. Encryption help ensure that information that is intercepted halfway would remain unreadable because the user has to have the correct password or key for it.
IP addresses are displayed as a series of four decimal numbers that are separated by period or dots. Another term for this arrangement is the dotted decimal format. An example is 192.168.164.8
Authentication is the process of verifying a user's credentials before he can log into the network. It is normally performed using a username and password. This provides a secure means of limiting the access from unwanted intruders on the network.
This is a mode of data exchange wherein two communicating computers do not use IPSec themselves. Instead, the gateway that is connecting their LANs to the transit network creates a virtual tunnel that uses the IPSec protocol to secure all communication that passes through it.
Analog connections - using conventional telephone lines;
Digital connections - using digital-grade telephone lines;
switched connections - using multiple sets of links between sender and receiver to move data.
In the event that one link fails, there will always be another available. Mesh topology is actually one of the most fault-tolerant network topology.
A large percentage of a network is made up of hardware. Problems in these areas can range from malfunctioning hard drives, broken NICs and even hardware startups. Incorrectly hardware configuration is also one of those culprits to look into.
A common way of dealing with such a problem is to use repeaters and hub, because it will help regenerate the signal and therefore prevent signal loss. Checking if cables are properly terminated is also a must.
Instead of having to visit each client computer to configure a static IP address, the network administrator can apply dynamic host configuration protocol to create a pool of IP addresses known as scopes that can be dynamically assigned to clients.
Profiles are the configuration settings made for each user. A profile may be created that puts a user in a group, for example.
Sneakernet is believed to be the earliest form of networking wherein data is physically transported using removable media, such as disk, tapes.
There are 4 protocols that are being managed by this layer. These are ICMP, IGMP, IP and ARP.
Rights refer to the authorized permission to perform specific actions on the network. Each user on the network can be assigned individual rights, depending on what must be allowed for that user.
A VLAN requires dedicated equipment on each end of the connection that allows messages entering the Internet to be encrypted, as well as for authenticating users.
IPv6, or Internet Protocol version 6, was developed to replace IPv4. At present, IPv4 is being used to control internet traffic, butis expected to get saturated in the near future. IPv6 was designed to overcome this limitation.
IEEE, or the Institute of Electrical and Electronics Engineers, is an organization composed of engineers that issues and manages standards for electrical and electronic devices. This includes networking devices, network interfaces, cablings and connectors.
RSA is short for Rivest-Shamir-Adleman algorithm. It is the most commonly used public key encryption algorithm in use today.
Mesh topology is a setup wherein each device is connected directly to every other device on the network. Consequently, it requires that each device have at least two network connections.
The maximum allowable length for a network segment using 100Base-FX is 412 meters. The maximum length for the entire network is 5 kilometers.