If a poller is not being used to monitor the network, you can remove the poller

from the monitoring system.

To remove a poller from the monitoring system, you must delete its record from

the NCMonitor Poller table, which removes the record from the Monitor Policy

editor. The ncp_poller process attempts to remove the relevant record from the

poller table and then exits.

Complete the following tasks to remove a poller from the monitoring system.

1. From the Network Manager server, issue the following command.

ncp_poller -deregister -domain [domain_name] -name [poller_name]

Note: When you issue this command, the record is deleted from the

NCMONITOR Poller table.

2. From the Monitor Policy Editor, edit each active policy to use a valid poller.