⟩ Drafters using AutoCAD version 2007 and newer will want to use the workspace called 3D Modeling to create 3D models. A. True B. False
A. True
Question and Answer:
Home 3D Modeling
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
Thermal efficiency of a gas turbine plant as compared to diesel engine plant (a) Higher (b) Lower (c) Same (d) May be higher or lower
Tell me what are Bevel Gears and what are its types?
Teflon is used for bearings because of (a) Low co-efficient of friction (b) Better heat dissipation (c) Smaller space constraint (d) All of the above
Antifriction bearings are (a) Thick lubricated bearing (b) Thin lubricated bearing (c) Ball & roller bearing (d) Plastic bearing
A closed cycle gas turbine works on (a) Carnot cycle (b) Rankine cycle (c) Joule cycle (d) Atkinson cycle
Mass balancing is done to (a) Avoid flutter (b) Increase bending stress (c) Reduce drag (d) Distributing mass on control surface
Principle effect of humidity is (a) Corrosion (b) Leaking from sealed enclosures (c) Permanent set of packing and gaskets (d) Differential contraction of metal parts
Tell me what are the method of development?
What is position of views in First Angle Projection?
Mohr’s circle can be used to determine following stress on inclined surface (a) Principal stresses (b) Normal stresses (c) Maximum shear stresses (d) All of the above
