⟩ What’s the difference between L1 and L2 cache?
Level 1 cache is internal to the chip, L2 is external.
Question and Answer:
Home A + (Plus) Hardware
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
Whenever you have a hardware resource conflict, it will more likely be an IRQ conflict rather than an i/o conflict because A. there are a lot more I/O addresses than IRQs. B. the BIOS sometimes has more of a problem controlling IRQs C. I/O addresses cannot conflict D. software tends to correct I/O conflicts E. software tends to mess up IRQs
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem? A. The port speed is set too high B. the modem has not been set up in control panel properties C. the phone line is plugged into the line-in port on the modem card D. the phone line out of the wall is plugged into the phone port on the modem card E. None of the above
What component would most likely cause a "parity error"? A. bad hard disk B. bad controller C. bad RAM D. bad software E. None of the above
Which provides the fastest access to large video files? A. Optical drives B. IDE hard drives C. SCSI hard drives D. EIDE hard drives E. None of the above
What is ospf?
A PCMCIA measuring 10.5mm is what type? A. type 1 B. type 2 C. type 1 and 3 D. type 3 E. None of the above
You can place an ISA device in an EISA slot. A. True B. False
When you boot a PC and don't hear any beep, this could suggest which of the following? A. The monitor is turned off B. Keyboard not plugged in C. Normal PC boot D. Bad or disconnected speaker E. None of the above
What is the file extension used by WIN95 to back up registry file when windows starts? A. .dat B. .dao C. .bak D. .tmp E. None of the above
A 2xx POST error code indicates a problem with A. RAM or ROM B. hard drive C. system board D. second adapter card E. CMOS battery
