⟩ Which Flags can be set or reset by the programmer and also used to control the operation of the processor?
Trace Flag,
Interrupt Flag,
Direction Flag.
Question and Answer:
Home 8086
- Share
Popular Answers:
* There is no answer to the above question yet.
More Questions for you:
What is the best ground for a conductive work bench? A. AC outlet B. Ground to bench C. To the motherboard D. To the PC's Chassis E. None of the above
When we are testing a fuse, we should set the Volt-OHM meter to what scale? A. AC B. DC C. AMPS D. OHMS E. None of the above
An anti static strap uses a small _____ to make sure you do not become the least path of resistance to the ground? A. capacitor B. diode C. transistor D. resistor E. None of the above
What resistance in ohms should be displayed when testing a speaker in a computer? A. Q Ohms B. 16 Ohms C. -200 Ohms D. Unlimited Ohms E. None of the above
Which best describes a fragmented hard drive A. The platters are bad B. Data files are corrupted C. Clusters of data are damaged D. Files are not stored in consecutive clusters E. None of the above
After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the A. System's floppy drive device driver B. Original IDE controller C. Floppy drive ribbon cable D. System's power supply E. None of the above
Which of the following is a type of preventative maintenance used on a hard drive? A. Disk check diagnostics B. Head alignment diagnostics C. Initializing D. Uninstalling programs E. None of the above
The 34-pin connection on an I/O card is for? A. floppy drive B. SCSI drive C. IDE drive D. zip drive E. None of the above
On a leased line installation a known good external modem shows no carrier detect light. Where is the problem most likely to be? A. In the modem B. In the phone line C. In the computer D. In the DTC equipment E. None of the above
Which hardware component controls serial port communications? A. ROM BIOS B. CPU C. DMA823 D. UART 16550 E. None of the above
